Most of us don't put 'em back on. So far I only removed the word pontiac off the deck lid.
Announcement
Collapse
No announcement yet.
Pontiac Lettering Peeling Off
Collapse
This is a sticky topic.
X
X
-
G6P member 340
G8 GT 334 0f 1st 888
Pedders Street II suspension. Pedders Strut Tower bar. VMS HSRK, VMS PCM/TCM tune, Forged and Stroked LS3, Garrett Turbo
Borla Cat back. SLP underdrive pulley. FAST ported 102 intake and TB ported. BMR trailing arms, Circle D 3200 stall converter.
20 percent tint by Scott's tinting and graphics.
-
If you take some fishing line and just stick it under a thick part of the badge when it's really cold out, a quick tug will usually take it off cleanly and in tact. I did this to remove the G6 part and it was basically in perfect condition. My GM badges I just ripped off, I'm sure you could stick them on again like that but prolly wouldn't stick very good since it lost half of it. Or you can buy some 3m trim adhesive and reafix it like that, it's very similar to what it on there already actually. Prolly the same stuff.
Comment
-
^ Very cool ... Thanks!
Can you buy the actual "g6" .. "gtp" .. so that if you do take 'em off, but wanted to replace them in a different spot, you'd have a fresh one to use? Im pretty sure I saw 'em somewhere but I dont remember where it was.. ebay I think, but not sure. =/
Comment
Comment