Just bought a 12mm intake manifold spacer for the G6 GXP From
Mace engineering in Australia.
The instructions say to use the stock bolts that are 195mm
But there to short. Needs to be more like 203mm.
Mace isn't responding to my e mails.
Has anyone else had this problem,
If so how did you go about getting this to work?
Mace engineering in Australia.
The instructions say to use the stock bolts that are 195mm
But there to short. Needs to be more like 203mm.
Mace isn't responding to my e mails.
Has anyone else had this problem,
If so how did you go about getting this to work?
Comment