If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I wanted to let you know that I used this thread to open up my passenger headlight today. I used it for my ANZO E.E. projector ones. I also used 265 degrees but I felt that I could have used 200-230 degrees. I might have been able to use less? I did mine for 10-15 minutes. I saw the butyl in mine dripping down and that's when I pulled the headlamp out. The whole time I did it, I was a little nervous. But no melted housing, just the butyl. Other than that, it was a success for me! Next time I do this, I'm painting up my chrome cover. Thanks Chase for this thread.
Comment