If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
On the ad it says you can put it anywhere flat.. so for the front you might have to bend it, the rear might be fine or you'd have to bend it slightly.
Mods: AIT Hood, Black EE's, Crab O3, 25% Tint all around, Matt Black Dipped Rims, LED's in Hood Scoops, Intake Resonator Delete, Blacked out Pontiac Darts, De-badge, Molded mud flaps, Flat Black grille surrounds, Flat Black window trim, GM logo Interior Re-Badge, Tinted Tail lights.
Future Mods: Flowmaster Super44, Matt Black Recessed Uppers, Matt Black Recessed Lowers (awaiting install), Eibach Drop, Interior LED's.
you will have to form it to your emblems. the front emblem bends on the grill and both the front and rear emblems the red arrowhead part is not flat, its kinda tapered in the middle. My overlays are just ones I cut myself out of 3m vinyl
remove the 4 clips off the top of the grill, u can see how its held on, i did one a while ago front bumper at work, if its not a speed nut then its double sided tape
remove the 4 clips off the top of the grill, u can see how its held on, i did one a while ago front bumper at work, if its not a speed nut then its double sided tape
I know how it comes off I was asking if it was going to be to big or too small scince the front emblem groves into the bumper a little
Comment