Seats....think it would fit?

[Lampoon]

Im guessing this came out of a coupe or a vert (due to the center console.....
think it would fit a sedan???



hey Bamm....didnt you try this??

eehhhhh.....on second thought it would mess up my ability to haul 3 back there (no center seat or belt) so I will prolly pass.....

[BAMBAMM]

Re: Seats....think it would fit?

I sure did do this with the Gold G6. these came out of a Coupe, the sides, you can't see! there is a huge gaping hole that viewable if you put into a sedan, cause otherwise they are covered by the body of the car in a coupe.

The biggest clue to tell if they are coupe or sedan is the curve of the seating area. These are not as round as the sedan seats are, they are closer to a right angle look, even though its not! thats the best way to tell.

the back section, where you back makes contact to the seat, for the rears is about an inch thinner on the coupe than the sedan, due to the curvature of the body on the coupe.

I hope this makes alot of sense, it does in my head..........

[Matts06GT]

Re: Seats....think it would fit?

So... You can do this then?? I am so confused!!

[BAMBAMM]

Re: Seats....think it would fit?

No, I wouldn't recommend putting that seat into your sedan!

Only reason I did what I did with my Gold G6 was that I had a stain that just would never come out............drunken roommate and his ability to vomit make for nasty seats!

I did it, but the seat you see here is for a coupe. the are longer in the seating portion and thinner in the back. It just didn't look right, but I didn't care at that point, I just did it.

So no, don't put coupe seats into a sedan, it just won't look right.

[Matts06GT]

Re: Seats....think it would fit?

Ok got it!!