ok i'm fixing to do an exhaust system on my gt coupe i'm taking out everything from the res and back gonna use magnaflow muffler into 2.5 piping and t into duels at the rear axle i'm tryin to decide on tips dunno if i want a 3'' or 4'' i kow the sound will vary need opinons
Announcement
Collapse
No announcement yet.
open on tips for custom exhaust
Collapse
X
-
just check out the other threads on exhausts, i'm not worrying about mine til summer. not many people have done their exhausts yet, but a couple people have and posted pics. are you getting the gtp rear fascia for the dual tips? also, isn't it really loud without any sort of res?-Mike #2 (the self-proclaimed tallest G6 owner)
http://www.cardomain.com/ride/2645383
VMS ECM, GT-R Exhaust, Dr. Speed Stage 3 CAI, 35% Llumar Tint, Redline Hood Struts, Vent Visors,
Pontiac Inset Upper Grilles #1, STB, Black Euro Tails, PowerSlot Rotors, Hawk Brake Pads
-
I feel it will be to loud with just the one so I am dropping in
two high flow mufflers in line. Replace the resonator
with a Magnaflow and the muffler in back with the
flowmaster. Should be deeper than stock but not too loud.
The tips make a difference other than cosmetic?
I didnt know that.
Ill let you know how these are
in a tad over a week when I get it installed:
Part #: 35136
Inlet: 2.5"
Outlet: 4"
Overall Length: 5"
Style: Rolled - Round - Angle Cut - Single Wall
Manufacturer: MagnaFlow
Material: T304 Stainless Steel
I didnt go with a double walled tip as they are
too expensive and these to me look just as good.
So why? Anyway....I have been planning this since Dec
so I better get off my ass and get it done!Please consider supporting G6P -Tap here
MODS:
Crab Intakes CAB, MPD Ram Air hood, Custom exhaust,
WAMS High Performance Tune and a whole lot more....
Comment
-
yeah from what i understand the larger the outlet of the tip will change the sound.. i cant what to hear the way your exhaust sounds that sounds like a good set up it may just sway my exhaust ideas lolyou wanna race or you wanna box.. magnaflow custom exhaust & injen intake
Comment
-
yea you better get that done ASAP , i want to know what it sounds like-Mike #2 (the self-proclaimed tallest G6 owner)
http://www.cardomain.com/ride/2645383
VMS ECM, GT-R Exhaust, Dr. Speed Stage 3 CAI, 35% Llumar Tint, Redline Hood Struts, Vent Visors,
Pontiac Inset Upper Grilles #1, STB, Black Euro Tails, PowerSlot Rotors, Hawk Brake Pads
Comment
-
lookin good, wish i could hear how it sounds-Mike #2 (the self-proclaimed tallest G6 owner)
http://www.cardomain.com/ride/2645383
VMS ECM, GT-R Exhaust, Dr. Speed Stage 3 CAI, 35% Llumar Tint, Redline Hood Struts, Vent Visors,
Pontiac Inset Upper Grilles #1, STB, Black Euro Tails, PowerSlot Rotors, Hawk Brake Pads
Comment
-
wouldn't the fascia need cut out for those? i do like it though-Mike #2 (the self-proclaimed tallest G6 owner)
http://www.cardomain.com/ride/2645383
VMS ECM, GT-R Exhaust, Dr. Speed Stage 3 CAI, 35% Llumar Tint, Redline Hood Struts, Vent Visors,
Pontiac Inset Upper Grilles #1, STB, Black Euro Tails, PowerSlot Rotors, Hawk Brake Pads
Comment
-
all i had done was i had the huge ass old muffler taken out in place is a flowmaster delta 50 with dual outlets.. i had to buy the GTP valence.. then the muffler shop that put it on had those tips (for trucks) but the fit the valence nicely so i told him to put them on.. i think they were like 30 dollars a piece..Stealth Grey G6 GT Coupe::Flowmaster duals with GTP valence:: Luminics Lows and Fogs::
Comment
-
Hey Brandon.....did you keep the resonator? Looks like
the same tips I have. Rolled angled cut....?
I have access to a sound clipper when I get it done.
The FLowmaster Muffler should be in by Wednesday.
SOOOON!!!Please consider supporting G6P -Tap here
MODS:
Crab Intakes CAB, MPD Ram Air hood, Custom exhaust,
WAMS High Performance Tune and a whole lot more....
Comment
Comment