SO I started to make some modifications to the Spyder headlights...that is take them apart lol. Its pretty easy to take them apart...all you have to do is remove all the screws, clips and take the harness out; lights bulbs, wires, rubber grommet etc,. Then pre heat your oven to about 200 degrees F and bake them for about 5 min... they should be easy to pry off then. After you do all that there are to more screws on the bottom that will allow you to take the inner part off of the lens and you should get something like this...
To take the projectors/xenon out you will have to get a small Philips screwdriver and unscrew the the one hidden screw that is to the left of the projector where you see a small rubber grommet.
***While you turn the knobs on the back of the housing to push the projector out***
After you did that you should get something like this...
This is how the inside of the projector looks if you decide to that the 4 screws on the front:
To take the halo rings out...you will have to take the 2 screws on the back out and its as easy as that...
If there is someone at a later stage in this retrofit then me...please feel free to post your strategies or thoughts...
To take the projectors/xenon out you will have to get a small Philips screwdriver and unscrew the the one hidden screw that is to the left of the projector where you see a small rubber grommet.
***While you turn the knobs on the back of the housing to push the projector out***
After you did that you should get something like this...
This is how the inside of the projector looks if you decide to that the 4 screws on the front:
To take the halo rings out...you will have to take the 2 screws on the back out and its as easy as that...
If there is someone at a later stage in this retrofit then me...please feel free to post your strategies or thoughts...
Comment