Announcement

Collapse
No announcement yet.

center console removal

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • center console removal

    does anyone have directions to remove the center console
    Avoid The Clap

  • #2
    Re: center console removal

    Ask asquarecan! He has pulled it out so build a sub enclosure into it!

    Comment


    • #3
      Re: center console removal

      You need to pull the lil panels on the sides of the dash whaen you open the doors, remove screws that hold dash. Remove all screws under drivers side dash and drop panel. Remove all scres under glovebox and drop glovebox and panel. Once those are all dropped, you can then remove center console.

      There is a nice write-up showing all screws in the how-to thread. I think by Ragingfish!!!


      OOOOOPPPPPPPSSSSSSSS. Scratch all that. I was removing the center panel.

      Blue Man Group Member NY Local 123

      Comment


      • #4
        Re: center console removal

        I did not type this but it is very informational!

        CENTER CONSOLE REMOVAL:

        1. Remove the right console trim plate. Refer to Console Trim Panel Replacement - Right .
        2. Remove the left console trim panel. Refer to Console Trim Panel Replacement - Left .

        -Panel Assembly, Console Trim

        Tip The console trim panel is secured with a hook and loop fastener at the forward edge.

        3. Remove the parking brake lever bezel. Refer to Parking Brake Lever Bezel Replacement .

        -Bezel Assembly, Park Brake
        Tip

        1. Apply the park brake.
        2. Use a plastic trim tool to release the retainer at the rear edge of the bezel.
        3. Slide the bezel and boot assembly over the park brake lever.



        1) Trim Cover, Console Bolt (Qty: 4)

        Tip
        • To gain access to the front console bolts and covers, the front seats need to be positioned in the full rearward position.
        • To gain access to the rear console bolts and covers, the front seats need to be positioned in the full forward position.

        2) Bolt, Front Floor Console (Qty: 4)

        Tighten 6 N·m (53 lb in)

        3) Console Assembly, Front Floor

        Tip

        1. There are 2 retainer clips located at the rearward edge of the shifter bezel. Care must be taken when lifting the console from this area to avoid damaging the shifter bezel.
        2. Disconnect the electrical connectors.
        [/quote]

        Hope this helps some

        Keith


        __________________________________________________ _________________
        Current Mods:e-badged, Re-q5, Custom sub console, Tinted Tails, Custom fiberglass woofer box. 2 Memphis PR's
        In Progress:: Katskinz... Half way there! Painted trim

        Comment


        • #5
          Re: center console removal

          thank you

          i got it
          Avoid The Clap

          Comment


          • #6
            Re: center console removal

            Good to hear!

            I have to pull mine out soon to put in my new console!

            BTW Welcome to the forum!

            Keith


            __________________________________________________ _________________
            Current Mods:e-badged, Re-q5, Custom sub console, Tinted Tails, Custom fiberglass woofer box. 2 Memphis PR's
            In Progress:: Katskinz... Half way there! Painted trim

            Comment

            Working...
            X