If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
has anyone taken apart their halo head lights? If so can you tell me how?
I want to swap out the white halos with red
1 Mile Remote Start, 2-way paging car alarm
30% Tint
Black Halo Headlight Harness (Halo's on a relay switch)
10000 HID Headlights (disabled DRL's)
LED Taillights
LED Fog Lights
20" Custom rims
Pioneer AVIC-N3
Took off the two side emblems (GM) and the Pontiac emblem on the rear
I saw that post. Arent the factory and after market lights different?
and i also want to know how easy/hard it is to take out the rings..
1 Mile Remote Start, 2-way paging car alarm
30% Tint
Black Halo Headlight Harness (Halo's on a relay switch)
10000 HID Headlights (disabled DRL's)
LED Taillights
LED Fog Lights
20" Custom rims
Pioneer AVIC-N3
Took off the two side emblems (GM) and the Pontiac emblem on the rear
The ones JP used to do WERE the aftermarkets..... they use a similar BLACK sealant. SO it shouldn't be a problem taking them apart... with caution of course.
Originally posted by BAMBAMM
I'm about the best wingman in the San Joaquin Valley...........I'm the guy that will hit on the ugly friend, so you can swoop in and bag the hottie friend.
well shit guess I'll just mess around with and and take pictures as I go... in case I do it right LOL
1 Mile Remote Start, 2-way paging car alarm
30% Tint
Black Halo Headlight Harness (Halo's on a relay switch)
10000 HID Headlights (disabled DRL's)
LED Taillights
LED Fog Lights
20" Custom rims
Pioneer AVIC-N3
Took off the two side emblems (GM) and the Pontiac emblem on the rear
good luck with the stress cracks. i had over $600 into my headlights, but with the stress fractures covering 80% of each lens and looking like shit, i tossed them.
so just taking them apart will cause the stress cracks?
Is there anywhere to buy just the cover then?
1 Mile Remote Start, 2-way paging car alarm
30% Tint
Black Halo Headlight Harness (Halo's on a relay switch)
10000 HID Headlights (disabled DRL's)
LED Taillights
LED Fog Lights
20" Custom rims
Pioneer AVIC-N3
Took off the two side emblems (GM) and the Pontiac emblem on the rear
You could email the seller to find out where they get them from, then email the manufacturer to ask for a custom set that haven't been sealed yet... only thing I can think of, that's what I was going to do for the Spyder headlights
It's not about how fast you get to your destination, it's about how you many heads
you turn when you get there...
You could email the seller to find out where they get them from, then email the manufacturer to ask for a custom set that haven't been sealed yet... only thing I can think of, that's what I was going to do for the Spyder headlights
asked everyone that sells them on ebay but no one will tell me where they get them from. The one site I found that actually carries them wont allow me to get any information... so pretty much, stuck between rock and a hard place!
1 Mile Remote Start, 2-way paging car alarm
30% Tint
Black Halo Headlight Harness (Halo's on a relay switch)
10000 HID Headlights (disabled DRL's)
LED Taillights
LED Fog Lights
20" Custom rims
Pioneer AVIC-N3
Took off the two side emblems (GM) and the Pontiac emblem on the rear
Comment