looks good! those are black ones?
Last edited by datacat; 01-24-2011 at 08:26 PM. Reason: Picture
These are sweet but I think im going with some eyelids on mine. I know some people are against them but I think the g6 headlights are too big, especially with these projectors. The low beam projector is too small and I think eyelids would take away from that a little bit. That's just my opinion but they still look great without them
datacat. if you look at the pic below. you see a long bronze/gold looking screw with an allen head. that adjust your head light up or down. park your car 25' from a wall. (Im sure if these headlights have the same dot in the middle of the headlight as the OEMs do) measure from the ground to the dot. then measure from the ground to measurement you got from the dot. thats where your cutoff should be at
Edited: The problem is my upper tie bar was damaged. They were supposed to repair it and get everything aligned. I just feel my lights are not lining up as they should. I'm pissed at the shotty repair job. I'm going to get this settled Monday
Last edited by datacat; 01-24-2011 at 08:30 PM.
I tried to aim the lights with no luck. Holes have to be drilled out like Lampoon did. I told the shop to drill holes to adjust them but of course they didn't along with a bunch of other things they didn't do right. My rad support or upper tie bar is bent, paints flaking off everywhere so I'll have to refinish that myself after drilling out the holes for lights. Not a happy camper...
Anyone else still getting condensation? I finally got my car fixed through GM so I just went out to aim my lights and there's condensation or frost along the inner corners. Is it just because it's so damn cold out?
Last edited by datacat; 01-21-2011 at 09:10 PM.
looks good man, hope the condensation goes away that would be really shitty if the seals no good, definitely need more pics though!
No...mine dried up within one day.....course it isnt real cold here.
Been through the rain etc and no moisture or leaking.
Please consider supporting G6P -Tap here
Crab Intakes CAB, MPD Ram Air hood, Custom exhaust,
WAMS High Performance Tune and a whole lot more....
It's been pretty cold -10 -15C
The condensation didn't have time to 'dry up' it just froze LOL I haven't been driving alot either so the lights haven't actually been on that much or warmed up...
Since you got a silver 6 also, could you take more shots including day light and from further out to so I can see if I'll like them on mine. Night shots like nice so far
Current: 2015 Volvo s60 t6 awd r-design platinum
Former: 2006 Pontiac G6 GTP 3.9L Sedan Silver loaded w/ GT-R Exhaust, CRABS CAB Intake w/ FPU, AIT Carbon Fiber hood & roof wing spoiler, GM Ground Effects Kit, Eagle Eyes black CCFL halo projectors, 18" Konig Airstrike rims, shadow chrome recessed upper/lower grilles, 35% tint all around, tinted tails, Kenwood Excelon X497 Head Unit, R1 concepts drilled/slotted rotors, silver door plate sills, Racingline STB, Bridgestone Potenza Pole Position tires, custom GTP floor/trunk mats, gm carbon silver interior trim kit, CF dart & pillar overlays/plate bracket, rs-1 cf/silver pedals, red calipers w/ GTP logos, chief badge replacements, red/silver painted engine/battery covers, windshield washer relocate
add some silicon around light and drill a couple 1/16th " holes in the back..should clear it right up
Mine cleared up after about a week. It's been very frigid in my area, as well.