I need to replace my ball joint on my passengers side of my car
I received the part in the mail and need this done
I was assuming it was just a few bolts, however after receiving the parts I found the ball joint is not threaded.
Is this just a press fit?
How do I remove the other and install the new control arm?
Is it just a matter of prying the old out and pressing the new on?
There are no clips, or pins?
THANKS IN ADVANCE , Photo's would be awesome too, but not needed
I received the part in the mail and need this done
I was assuming it was just a few bolts, however after receiving the parts I found the ball joint is not threaded.
Is this just a press fit?
How do I remove the other and install the new control arm?
Is it just a matter of prying the old out and pressing the new on?
There are no clips, or pins?
THANKS IN ADVANCE , Photo's would be awesome too, but not needed
Comment